The paint foams less when applied,
making it easy to paint parts with fine bumps!
The bristles are dense and packed together so it is difficult for air to get between the bristles, making it difficult to create a lather.
Because it is less likely for air to get in, it can be applied to parts with small irregularities without creating bubbles.
● Compared to conventional Kamifude, this series has a very short handle.
The short handle brings the center of gravity closer to your hand, making it less likely to shake and much easier to handle. You can choose the grip that is easiest for you to paint with, so you can enjoy brush painting.

● It also retains the features of the traditional Kamifude.

The bristles are made of pure Japanese synthetic bristles (PBT) that are also designed to be strong.
The brushes themselves are also made by Japanese brush craftsmen who specialize in artificial hair, and each brush is made by hand.
When animal hair brushes are immersed in solvents, the hair tends to get damaged, break off, or become brittle, but Kamifuji's hair is made of PBT bristles that are resistant to solvents, so it is less likely to get damaged.
The glue that holds the brush tip in place is also solvent-resistant, so the brush tip will stay in good condition for a long time.
The stiffness has been adjusted to make it easier to paint models with a brush, so the tip is more flexible than that of typical synthetic fiber brushes.
We have a variety of brush tip shapes so you can use them according to the painting situation.
If the brush tip is too short, the amount of water absorbed into the paint will be reduced, causing the paint to dry out quickly.
For this reason, we design the length of the brush tip to strike a balance between ease of drawing and water absorption.
The specially processed PBT bristles allow even bent bristles to be restored to their original straight tip by using hot water of 90°C or higher.
How to fix a brush with bent bristles:
Remove any dirt from the brush before soaking it in hot water.
*Be careful not to get burned as the water used is over 90℃.

1. Fill a heat-resistant container with hot water of 90°C or higher and immerse the tip of the bent brush for around 10 seconds.
2. Use the wall of the container with hot water to straighten the bent part of the bristles.
3. Pull the brush up along the wall while maintaining the straightness.
4. Check that the base of the brush you pulled up is straight, then let it dry and you're done.

*If the bristles have reached the end of their life, they may not be able to be straightened.
*Please note that if the hot water becomes lukewarm during the process, the brush will not be able to be straightened properly.